Ceramic & Porcelain

We offer a dispersing and deflocculating agent that improve the wetting and rheological properties of the clay body. By using these additives, it makes the moist clay body less sticker, easy to handle, shorter drying time needed, earlier green strength gain, reduce shrinkage and smoother finishing of the end product.

Porcelain actually refers to a wide range of ceramic products that have gone through baked at a very high temperature, in order to achieve glassy, vitreous, especially good qualities like translucence and low porosity. Typically, the most familiar porcelain goods are decorative table China, dental crowns, electrical insulators, and chemical ware. Not everyone is aware of the primary components, which include clays, feldspar or flint, and silica, every substance is characterized by small particle size. Normally the craftspeople will make use of these raw materials and combine them in varying amounts until you have fully achieved your desired unfired or fired properties.

What matters to us is how you can control the quality of your porcelain. You can control by making sure the character of the raw materials you use is suitable and sufficient, or else, they will not be hard or easy to mold. You should also know that the fired and unfired properties of the porcelain are most likely to get affected by the chemical composition, particle size distribution, mineral phase, including the surface area of the colloidal. Whereas the fired porcelain is being measured by its strength, color, porosity, and thermal expansion. Meanwhile, the unfired properties are evaluated for their plasticity, shrinkage, viscosity, and strength.

Apart from that as well as during the manufacturing process, after you have selected the raw materials and the amounts you desired to weigh, there are a few preparation steps that you must go through. As for the first step, you have to crush and purify the raw materials before you mix them all together and subject them to four forming processes which include soft plastic forming, stiff plastic forming, pressing, or casting, that is depending on the type of ware that you produced. Hence, if you are looking for the best material for your porcelain and ceramic, you can always check out us as your chemical manufacturer in Malaysia.

Our dispersing and deflocculating agents will definitely improve the properties of the clay body. We can assure that when you use these additives, you will find that the clay body will be more moisturized and less sticky, which makes it more convenient to handle, dry faster than the time you noticed, reduce shrinkage and be smoother as a final result.

Calcium Lignosulphonate

Imagine it as the glue that will hold the clay together and work as our dispersing and deflocculating agent.

Sodium Lignosulphonate

This substance is very good because of its preservative properties. Apart from the functionality as dispersing and deflocculating agent for the ceramic tiles and porcelain, it is also being used in construction and mineral powder as well.

Polycarboxylate

Because of its strong plasticizing ability, we would like our customers to supply this to our customers as well as the dispersing and deflocculating agent in porcelain and ceramic.